羧甲基纤维素钠修饰的聚氨酯泡沫制备磁性吸油材料

采用聚氨酯泡沫为模板,依次修饰羧甲基纤维素钠(CMC)、Fe~(3+),在惰性气氛中高温热处理反应,制备多孔结构的磁性吸油材料.用光学显微镜、扫描电子显微镜、红外吸收光谱、X-射线衍射、接触角等技术对材料进行表征.详细考察了加热反应温度、CMC浓度和Fe~(3+)浓度对材料吸油性能和磁性的影响规律.实验表明,当加热反应温度选择230°C,CMC浓度为0.3 wt%,FeCl_3浓度为0.1 mol/L时,材料吸油性能最佳,对正己烷、二甲苯、环己烷、甲苯、乙酸乙酯、氯仿、机油、原油等有机溶剂和油类分子的吸附容量为10倍左右.磁性多孔材料具有明显的亲油、疏水特性,水的接触角达115.9°,同时材料密度只有0.036g/cm~3,能够漂浮于水面,实现对水面有机溶剂的快速吸附.吸附后的材料在外界磁场控制下,能够通过磁分离方式从水面快速分离.该材料具有良好的循环利用性能,可重复使用20次以上,吸油性能仍然保持良好.     

EDTA快速滴定法测定矿石中的氧化铝

介绍一种利用二乙基二硫代氨基甲酸钠分离后以EDTA滴定测定矿石中铝的新方法。锰矿样品用Na OH,Na_3PO_4和Na_2O_2混合熔剂熔融,消除Ca,Mg,Ti的干扰,用含无水乙醇的热水浸取,其中的Mn变为Mn O2沉淀析出,干过滤,定容。将滤液中和至弱酸性,加入二乙基二硫代氨基甲酸钠,一些金属阳离子形成难溶水的络合物而分离,再次过滤,一定量的滤液与过量的EDTA标准溶液反应,用锌标准溶液滴定剩余的EDTA,即得氧化铝的含量。该法采用二甲酚橙为指示剂,同时加入少量氯化十六烷基吡啶,滴定终点颜色突变明显,改善了测量精密度,操作易于掌握。样品测定结果的相对标准偏差为0.42%~1.08%(n=5),加标回收率为97.39%~99.94%。分析过程只需滴定一次,且不使用含铅、铜、氟溶液,方法便捷环保。     

On the behaviour of Eu oxo-species in molten NaBr–NaI (0.77:0.23) mixture at 973 K

The interaction of Eu₂O₃ with molten NaBr–NaI (0.77:0.23) mixture at 973 K was studied by sequential addition method with the use of YSZ membrane oxygen electrode for controlling of course of the process. The Red-Ox process is accompanied with formation of EuO in the melt. The total solubility of EuO (sum of concentration of Eu²⁺, O^2–, non-dissociated EuO) in the molten NaBr–NaI at 973 K (mole fraction 2.7 × 10^–4) is considerably lower than in pure NaI melt (4.2 × 10^–4), which can be explained using the ‘hole’ model by reduction of a number of holes of comparable with EuO particle size because of addition of smaller bromide ion to the iodide melt.

The solubility of EuO is appreciably affected by its dispersity and the value of surface energy causing these solubility changes is estimated as 37 J m^–2.     

Two copper(II)-bbtz modified Keggin and β-octamolybdate compounds captured in one-pot under hydrothermal conditions

Under hydrothermal conditions two compounds based on Keggin and β-octamolybdate, respectively, [Cu₂(bbtz)₄(SiMo₁₂O₄₀)] (1) and [Cu₂(bbtz)₄(Mo₈O₂₆)]_1/2·H₂O (2) (bbtz = 1,4-bis(1,2,4-triazol-1-ylmethyl)benzene), were synthesized in one-pot and characterized by single-crystal X-ray diffraction, elemental analyses, and IR spectroscopy. In compound 1, two adjacent wave-like Cu^II-bbtz lines are connected by SiMo₁₂ anions and bbtz to generate a ladder-like chain. Adjacent chains share the same Cu^II ions to build a three-dimensional (3-D) framework. In compound 2, the β-Mo₈ anions link Cu₃(bbtz)₂ subunits alternately to form a one-dimensional (1-D) chain. These chains connect each other through sharing Cu^II ions and a 3-D network is constructed. Moreover, we studied the electrocatalytic and photocatalytic activities of these two compounds. The results indicate that 1 and 2 show good electrocatalytic performance for the reduction of nitrite and bromate; they also exhibit photocatalytic properties for degradation of MB and RhB.     

Interrelationship between total volatile organic compounds emissions,structure and properties of natural rubber/polycaprolactone bio-blends cross-linked with peroxides

Natural rubber/polycaprolactone (NR/PCL) bio-based blends with different organic peroxides were prepared using an internal batch mixer and subsequently cross-linked at 170 °C. Two types of commonly used organic peroxides, dicumyl peroxide and di(tert-butylperoxyisopropyl)benzene peroxide, were applied as free-radical initiator. Cross-linking efficiency of NR/PCL blends were investigated using oscillating disc rheometer measurements, followed by infrared spectroscopy, thermogravimetric analysis, differential scanning calorimetry, dynamic mechanical analysis and tensile testing. Total volatile organic compounds (TVOCs) emissions were determined using headspace analysis integrated with gas chromatography with flame ionization detector. Determined TVOCs emissions varying in range 21.6–52.1 μg/g and generally value of this parameter decreased with increasing content of PCL phase in studied blends or with application of more efficient di(tert-butylperoxyisopropyl)benzene peroxide as cross-linking agent. It was found that increasing of TVOCs parameter indicated deterioration of mechanical properties of NR/PCL blends, which corresponded with the changes in chemical structure and thermal properties of cross-linked NR/PCL. This confirms that evaluation of TVOCs parameter is interesting alternative for “conventional methods” to characterization of the studied bio-based blends.     

Improved separation and size characterization of gold nanoparticles through a novel capillary zone electrophoresis method using poly(sodium4‐styrenesulfonate) as stabiliser and a stepwise field strength gradient

A novel capillary zone electrophoresis (CZE) method was developed for an improved separation and size characterization of pristine gold nanoparticles (AuNP) using uncoated fused‐silica capillaries with UV‐Vis detection at 520 nm. To avoid colloid aggregation and/or adsorption during runs, poly(sodium 4‐styrenesulfonate) (PSS) was added (1%, w/v) in the running buffer (CAPS 10 mM, pH 11). This polyelectrolyte conferred an enhanced stabilization to AuNP, both steric and electrostatic, exalting at the same time their differences in electrophoretic mobility. Resolution was further and successfully improved through a stepwise field strength gradient by the application of 25 kV for the first 5 min and then 10 kV. Migration times varied linearly with particles diameters showing relative standard deviations better than 1% for daily experiments and 3% for interday experiments. A comparison with the size distribution obtained by transmission electron microscopy (TEM) allowed assessing that the electrophoretic profile can reasonably be considered as representative of the effective size heterogeneity of each colloid. Finally, the practical utility of the proposed method was demonstrated by measuring the core diameter of a gold colloid sample produced by chemical synthesis which was in good agreement with the value obtained by TEM measurements.     

Poly(acrylamidoglycolic acid) nanocomposite hydrogels reinforced with cellulose nanocrystals for pH-sensitive controlled release of diclofenac sodium

In this study, a non-cytotoxic and pH-sensitive poly(acrylamidoglycolic acid) based nanocomposite (PAGA-NC) hydrogels reinforced with cellulose nanocrystals (CNCs) was synthesized using redox free radical polymerization. The successful formation and crystalline behaviour of PAGA-NC hydrogels was verified by fourier transform infrared (FTIR) spectroscopy and X-ray diffraction (XRD) analyses. The results showed that morphological, rheological and mechanical properties of the PAGA-NC hydrogels were strongly influenced by the CNCs content. Moreover, swelling properties were investigated, and the results suggested that they behaved as pH sensitive manner. The in vitro MTT assay showed that the PAGA-NC hydrogels are cytocompatibile to NIH-3T3 fibroblast cells. In addition, diclofenac sodium (DCF) model drug was successfully encapsulated into these PAGA-NC hydrogels via equilibrium swelling method. The in vitro release of DCF from PAGA-NC hydrogels was retained at pH 1.2 and maximum release was observed at 7.4, revealing as potential candidates for controlled release carriers for oral drug delivery applications.     

Sensitivity enhancing injection from a sample reservoir and channel interface in microchip electrophoresis

The stacking of a cationic analyte (i.e., rhodamine B) at the interface between a sample reservoir and channel in a microchip electrophoresis device is described for the first time. Stacking at negative polarity was by micelle to solvent stacking where the dye was prepared in a micellar solution (5 mM sodium dodecyl sulfate in 25 mM phosphoric acid, pH 2.5) and the channel was filled with high methanol content background solution (70% methanol in 50 mM phosphoric acid, pH 2.5). The injection of the stacked dye into the channel was by simple reversal of the voltage polarity with the sample solution and background solution at the anodic and cathodic reservoirs of the straight channel, respectively. The enrichment of rhodamine B at the interface and injection of the stacked dye into the channel was clearly visualized using an inverted fluorescence microscope. A notable sensitivity enhancement factor of up to 150 was achieved after 2 min at 1 kV of micelle to solvent stacking. The proposed technique will be useful as a concentration step for analyte mixtures in simple and classical cross‐channel microchip electrophoresis devices or for the controlled delivery of enriched reagents or analytes as narrow plugs in advanced microchip electrophoresis devices.     

Sodiation‐based in‐source collision for profiling of pyranocoumarins in Radix Peucedani (Qianhu): utility of sodium adducts' stability with in‐source collision

Full scan mode of liquid chromatography‐mass spectrometry equipped with an electrospray ionization source offers a chance on global detection of complicated components; however, the scan mode carries significant challenges in rapidly capturing information of analysts. Sodiation‐based in‐source collision was proposed here, as a technique for rapid detecting untargeted analytes in full scan analysis, which was based on the stability of sodium adducts and the nonselectivity of in‐source collision. Then the technique was applied to profile of angular‐type pyranocoumarins (APs) in Radix Peucedani, with full scan analysis performed at two specific in‐source collision energy: a high energy 50 V that is tolerated by the sodium adducts of APs, and a low energy 10 V, at which abundant adducts were offered. The spectra list of two average mass spectra was exported, and stable ions were selected based on the intensity ratio of standards at the two collision energy. Then 27 plausible [M + Na]⁺ m/z values of APs were acquired after filtering the fragment ion and isotope ions and validating with [M + NH₄]⁺. Eighty‐two APs finally were tentatively identified based on their accurate spectral data of MSⁿ, fragmentation rules, and elution order regardless of their absolute configuration, which included 25 reported APs from Peucedanum praeruptorum Dunn. The technique provided a novel application of sodium adduct in qualitative analysis. And it was valuable for rapidly capturing information of analytes in full scan analysis, not only for APs but also for other compounds that could form sodium adducts. Copyright © 2017 John Wiley & Sons, Ltd.     

Enhanced Fluorescence Imaging and Photodynamic Cancer Therapy Using Hollow Mesoporous Nanocontainers

Here we show that “off‐on” type of photodynamic therapy agents could be developed using hollow mesoporous silica nanoparticles (HMSNPs), which can be used not only for enhancing delivery of photosensitizers to cancer cells but also for enabling switchable optical properties of the photosensitizers. Fluorescence and singlet oxygen generation of the photosensitizer‐loaded HMSNP are turned off in its native state. In vitro cell studies showed that this HMSNP‐based “off‐on” agent may have potential utility in selective fluorescence detection and photodynamic therapy of cancers.